Thermal Camera
- ThermaScope HDT kiln and cooler cameras improve operational efficiency and facilitate the combustion control process while enabling safe compliance with pollution minimising protocols.
- ThermaScope HDT aids in detecting snowmen, red rivers and other process anomalies to make routine plant maintenance and shutdowns more predictable and less disruptive to production.
- Display format: 1280x720 (HD)
- Dynamic range: >115dB
- Colour resolution: 12 bit
Thermal Camera
- Thermoteknix's high-definition, high-speed ThermaScope HDC colour camera provides high quality imaging from inside the kiln and or cooler.
- ThermaScope HDC cameras deliver exceptional detail and visualisation of your process in real time.
- Detection of magnetic lines for line guidance
- The sensor reliably differentiates between up to three lanes
- Resolution 1 mm, repeatability 1 mm
- CANopen, Modbus RTU RS-485
- Rugged aluminum housing
- Easy installation: Thin housing design and different measurement area variants
Steel Cord Conveyor Belts
- Pipex and Piflex are rubber conveyor belts designed for tubular conveyor systems equipped with a Textile or a Steel Cord carcass, respectively.
- Wear resistant
- Oil resistant
- Heat resistant
Hot-wet Extractive gas analyzers
- CEMS solutions MCS100FT
- The FTIR measuring principle allows the simultaneous determination of more than 12 measuring components – tailor-made for the particular requirements of the customer.
- Lowest approved HF measuring range: 0 ... 3 mg/m³
- Automatic spectrum adjustment via AutoVAL for reliable measuring values
- Approved according to EN 15267
- Emission monitoring in waste incineration plants
- Effective HF limit value monitoring, e. g., in aluminum production
- Monitoring of gaseous emissions in cement plants or power stations
Sales Promotion
- Medium: Fluids
- Measurement: Switch
- Probe length: 117 mm
- Process pressure: –1 bar ... 64 bar
- Process temperature: -50 °C ... +150 °C, See safety notes for ATEX devices
- ATEX approval: ATEX II 1/2G Ex db IIC T6...T2 Ga/Gb +WHG
- WHG approval: ✔
- Output signal: 1 x PNP/NPN
- Supply voltage: Volt-free transistor output PNP/ NPN: 10 V DC ... 55 V DC
Sales Promotion
Features:
- Process connection: Thread G ½ A according to DIN 3852-E
- Insertion length/diameter of probe: 150 mm / 6 mm
- Maximum process pressure: ≤ 150 bar
- Measuring range: –20 °C ... +80 °C
- Power supply: 15 V DC ... 35 V DC
- Switching output: 1 x PNP + 4 mA ... 20 mA
- Connection type: M12 round connector x 1, 4-pin
Sales Promotion
- Medium: Liquid, gaseous
- Pressure type: Gauge pressure
- Measuring range: 0 bar ... 10 bar
- Process temperature: –30 °C ... +100 °C
- Power supply: 14 V DC ... 30 V DC
- Switching output: 0 V ... 10 V, 3-wire
- Connection type: M12 round connector x 1, 4-pin
Sales Promotion
- Medium: Liquid, gaseous
- Measuring range: –1 bar ... 24 bar
- Process temperature: –20 °C ... +85 °C
- Process connection: G ½ B according to EN 837
- Power supply: 15 V DC ... 35 V DC
- Switching output: 1 x PNP + 4 mA ... 20 mA
- Connection type: M12 round connector x 1, 4-pin
Sales Promotion
- Communication interface: Incremental
- Shaft diameter: 10 mm
- Pulses per revolution: 360
- Power supply: 10 ... 32 V
- Communication Interface detail: HTL / Push pull
- Number of signal channels: 6-channel
- Connection type: Male connector, M23, 12-pin, radial)
- Enclosure rating: IP67/IP65
Sales Promotion
- Communication interface: Incremental
- Shaft diameter: 6 mm
- Pulses per revolution: 512
- Power supply: 10 ... 32 V
- Communication Interface detail: HTL / Push pull
- Number of signal channels: 6-channel
- Connection type: Male connector, M23, 12-pin, radial
- Enclosure rating: IP67/IP65
Sales Promotion
- Communication interface: Incremental
- Mechanical design: Through hollow shaft
- Shaft diameter: 12 mm
- Pulses per revolution: 2,000
- Power supply: 10 ... 32 V
- Communication Interface detail: TTL / RS-422
- Number of signal channels: 6-channel
- Connection type: Cable, 8-wire, universal,(1.5 m)
- Enclosure rating: IP67/IP65