Hot-wet Extractive gas analyzers
- CEMS solutions MCS100FT
- The FTIR measuring principle allows the simultaneous determination of more than 12 measuring components – tailor-made for the particular requirements of the customer.
- Lowest approved HF measuring range: 0 ... 3 mg/m³
- Automatic spectrum adjustment via AutoVAL for reliable measuring values
- Approved according to EN 15267
- Emission monitoring in waste incineration plants
- Effective HF limit value monitoring, e. g., in aluminum production
- Monitoring of gaseous emissions in cement plants or power stations
Hot-wet Extractive gas analyzers
- CEMS solutions MCS100E HW
- Measured values: CH4, CO, CO2, H2O, HCl, N2O, NH3, NO, NO2, O2, SO2
- The MCS100E HW is an analyzer system for the extractive measurement of up to 8 IR active gas components.
- Emission monitoring in waste incineration plants
- Monitoring of incinerators with secondary fuels
- Flue gas monitoring in cement plants
- Emission monitoring in refineries
- Emission monitoring of land-based, heavy fuel fired diesel engine power plants
Hot-wet Extractive gas analyzers
- CEMS solutions MCS200HW
- The MCS200HW is a multi-component analyzer system for continuous monitoring of up to 10 IR measurement components in flue gases of industrial combustion plants
- Measured values: CH4, CO, CO2, Corg, HCl, H2O, H2SO4, NH3, NO, NO2, N2O, O2, SO2, SO3
- Emission monitoring for waste incineration plants as well as power plants and plants with co-incineration, e.g. cement plants
- Measurement of nitrogen oxides (NO, NO2, N2O) in nitric acid plants
- SO3 monitoring in coal-fired power plants
