- According to ISO 15552
- Ø 32 mm … 125 mm
- stroke: 2800 mm
- Fully assembled, tested working unit
- With series PRA and TRB
- Optional: low friction, MSS (Modular Sealing System), ATEX
Series CVI Cylinder Valve units AVENTICS™
- The AVENTICS Series CVI is a cylinder valve unit with two ISO cylinder Series and five freely combinable valve Series, you can custom-configure individual units online
- According to ISO 15552
- Ø 32 mm … 125 mm
- Stroke: 2800 mm
At a glance:
- The AVENTICS Series CVI is a cylinder valve unit with two ISO cylinder Series and five freely combinable valve Series, you can custom-configure individual units online.
- Cylinder valve units provide a solution for integrated, decentralized pneumatic applications, such as flap controls in large-scale facilities.
Features:
- According to ISO 15552
- Ø 32 mm … 125 mm
- stroke: 2800 mm
- Fully assembled, tested working unit
- With series PRA and TRB
- Optional: low friction, MSS (Modular Sealing System), ATEX
You can download more at the document here: Download
Related products
Hot-wet Extractive gas analyzers
- CEMS solutions MCS200HW
- The MCS200HW is a multi-component analyzer system for continuous monitoring of up to 10 IR measurement components in flue gases of industrial combustion plants
- Measured values: CH4, CO, CO2, Corg, HCl, H2O, H2SO4, NH3, NO, NO2, N2O, O2, SO2, SO3
- Emission monitoring for waste incineration plants as well as power plants and plants with co-incineration, e.g. cement plants
- Measurement of nitrogen oxides (NO, NO2, N2O) in nitric acid plants
- SO3 monitoring in coal-fired power plants
General Service Valves
- Valve Actuation: Solenoid
- Body Material: Aluminum
- Media: Air, Inert Gas, Liquid Propane Gas, Natural Gas, Oxygen
- The ASCO Series 214 gas shutoff valves are specifically designed for on-off control of fuel gas in commercial and industrial gas burners.
- Broad ambient range of -40°F to 140°F is ideally suited for frigid and hot environments
Signal isolation
- Input mA: -1 to +50 mA
- Input impedance: 10 Ω
- Adjustments – Zero: Any value within range limits
- Adjustments – Minimum spans: 0,4 mA
- Output: 4-20 / 20-4 mA
- Galvanic isolation: 1500 VAC, 1 min
- Power supply: 7,5 to 36 VDC
- Typical accuracy: ±0,1 % of span
ELETEX
Belts designed to be used in bucket elevator plant only. The special construction of the reinforced polyester-nylon fabrics assures the use of such belts also for severe loading requirements. The result are the following:
- Polyester warp assures high resistance to heavy working conditions.
- Nylon weft guarantees transverse tearing strength and strong bolt holding.
Scattered light dust Measuring Devices
- Measurement independent of gas velocity, humidity and particle charge
- Approved according to EN 15267
- For medium to large duct diameters
- Emission monitoring of power stations and waste incineration plants
- Monitoring of dust concentrations downstream of filter plants
- Monitoring of dust loads in factory workshops
- Control of fresh air supplies and exhaust air plants
