Steel Cord Conveyor Belts
- Pipex and Piflex are rubber conveyor belts designed for tubular conveyor systems equipped with a Textile or a Steel Cord carcass, respectively.
- Wear resistant
- Oil resistant
- Heat resistant
Rubber Conveyor Belts
- Flexobord belts are based on the following main components:
Base belt
Sidewalls
Cleats
- The complete range of SIG Rubber Conveyor Belts is produced according to the international standards
- This cross stabilized base belt can be sold as indipendent product with the brand name CROSSRIGID®.
Rubber Conveyor Belts
- ARABELT® is a rubber conveyor belt characterized by only one ply with a special construction named “straight warp”.
- Two other properties make aramid similar to steel: high heat and flame resistance.
- High working temperature
- Density similar to textile fibres
- Tensile and elongation similar to steel cord
Rubber Conveyor Belts
- High impact, tear and cutting resistance thanks to its special double reinforced weft
- Superior longitudinal flexibility that allows smaller pulleys
- Very low permanent elongation guaranteed by straight warp construction
- High efficiency with mechanical jointing
Rubber Conveyor Belts
- Wide selection of cover compounds
- Very low permanent elongations
- Maximum load support
- High resistance to tear and cutting
- Good impact resistance
- Apt to mechanical fasteners
- Humidity proof
Rubber Conveyor Belts
- SPINATEX R15
- SPINATEX G15
- SPINATEX G25
SIG reserves the right to introduce at any time such modification as would seem justified by continual development and improvement.
Dimensional tolerances: ISO 251
ELETEX
Belts designed to be used in bucket elevator plant only. The special construction of the reinforced polyester-nylon fabrics assures the use of such belts also for severe loading requirements. The result are the following:
- Polyester warp assures high resistance to heavy working conditions.
- Nylon weft guarantees transverse tearing strength and strong bolt holding.
ELEMENT
- The structure of ELEMET elevator belts is a steel carcass composed by a strong warp of steel cord with suitable elastic modulus such to reach the best compromise between low elongation and good flexibility.
- Rubber covers for elevator belts have two main functions: protection of the carcass against material and moisture aggression, assurance of the perfect bucket holding up without bolt loosening in course of time.
- Superior temperature resistance
ELEMENT
- The structure of ELEMET elevator belts is a steel carcass composed by a strong warp of steel cord with suitable elastic modulus such to reach the best compromise between low elongation and good flexibility
- Rubber covers for elevator belts have two main functions: protection of the carcass against material and moisture aggression, assurance of the perfect bucket holding up without bolt loosening in course of time
- Superior temperature resistance
Steel Cord Conveyor Belts
- Excellent cut and tear resistance
- Low elongation
- High tensile strength
- Good impact resistance
- Excellent longitudinal flexibility
- Very good troughability
Steel Cord Conveyor Belts
- High transversal stiffness
- Double steel breaker in the covers
- Minimum lateral supports required
- High longitudinal flexibility
- Small pulley required
- UV – ozone total protection
- Customization design
Steel Cord Conveyor Belts
- RIPSAVE is an EP (polyester / nylon) multiply belt equipped with special and highly flexible transversal
- steel reinforcement.
- Steel wires properties are such as to guarantee the absence of any belt stiffening and the perfect integration with the fabric carcass.
- The steel reinforcement assures the same performances as EP textile belts with higher resistance to cut, impacts and tears.
- Thanks to its particular construction, RIPSAVE can be installed and joined as traditional EP textile belts.
